Thermoplastic road markings vary in thickness between 1. It is the ideal kind of paint for reflectorized traffic paint applications. It offers increased resistance to road wear and tear and tropical climate conditions. In winter climates, thermoplastics are very susceptible to snow plows due to its raised structure and can be sheared completely off, leaving no marking on the road. Thermoplastics typically have a service life of 3-5 years, depending on conditions. It hardens quickly and can be driven over after just a few minutes. It can be produced in any colour and is suitable for car parks, factory walkways, and many other areas. Thermoplastic can be used very effectively for large anti-skid areas on roads and pedestrian walkways by adding glass beads. It is a mixture of glass beads, binder, pigment and filler material. Thermoplastic is a long life road marking material that was first used in the USA in 1958, followed quickly by its introduction into many countries throughout Europe. Please refer the material safety data sheet prior to using the product.īrightline Thermoplast Private Limited Hot melt Retro Reflective Thermoplastic Road Marking Paint. Some common features to consider are Type and Reflector Color. While these are popular, we recommend ensuring that the Reflectors you consider have the right mix of features and value. contact of the molten product with skin would lead to thermal burns, flush with cold water, do not remove material as it would lead to very tissue damage. These Reflectors are the most popular among Lowe’s entire selection. avoid eye contact, if contacted, wash copiously with water. do not inhale product or fumes, do not ingest. A lower gloss reflective bright brass with gold tones. Minimise dusting of the material during use of personal protective equipment's like facemask, google, heat resistant gloves and protective clothing while handling the material is recommended. Custom and Specialty Powder Coating Colors in stock for same day shipment in small or large by.Drop-on glass beads must be immediately deposited after thermoplastic application. The change in colour indicates that the material has been scorched owing to overheating and needs to be discarded. Do not hold thermoplastic above 180✬ for more than 6 hours do not heat the material above 220✬ at any point in time. For aged asphalt roads and concrete road's application of a primer coat is recommended for proper bonding of the material with the road surface ensure that the primer is thoroughly dry and void of solvent prior to application of the thermoplastic material. Heavy deposits of paints requires removal. Ensure that the road surface is clean, free from dust and moisture. Heat the material to 180 - 200 ☌ in the pre-heater with adequate agitation till the material becomes a homogenized liquid.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |